Your wardrobe, made to measure.

Choose the shape, the dimensions and every detail. The drawing updates as you make your choices. The quote is prepared after we have reviewed the project.

Step 1 of 7 · Measurements and type

Measurements and type

Enter the measurements and shape of your wardrobe

How to complete this step

In a few minutes you will have your wardrobe drawn up and ready to request a quote. There is no need to be exact: we take the final measurements at your home before anything is made.

  1. Choose the shape that most closely matches your space.
  2. Say whether the wardrobe is fitted into an alcove or freestanding.
  3. Enter the width, height and depth in millimetres (300 cm = 3000 mm). You can also type «240 cm» or «2.4 m».
  4. Move on to the next step: you can go back whenever you like without losing anything.
Frequently asked questions
How do I measure?
Measure the width at three points (bottom, middle and top) and the height on the left and on the right, then use the smallest measurement. The depth runs from the back wall to where you want the front of the wardrobe to sit.
What if I don’t have exact measurements?
Enter approximate measurements: they are fine for the design and a first idea of cost. We take the final ones at your home, before manufacture.
Which shape should I choose?
Straight: along a single wall. Under-stairs or Sloping ceiling: the height changes from one side to the other. Corner / L-shaped or U-shaped: takes up two or three walls. Other shape: you describe it and we look at it with you.
Fitted or freestanding?
Fitted: goes between walls; you give the measurements of the alcove and we allow for gaps and trims. Freestanding: the sides are visible; you give the outside measurements of the wardrobe.
What depth do I need?
For hanging clothes on hangers, 600 mm is typical. Under the «Depth» field you will see the minimum for hanging with the doors you have chosen.
How do I enter a sloping ceiling or an under-stairs space?
Enter the height on the left and on the right, as seen from the front; one of the two can be 0. «Swap sides» switches them over.
Measurements and type

These measurements are a starting point. Enter your own or confirm that they match your space.

Where will the wardrobe go?

Measurements

mm

From side to side, along the front. In mm: 300 cm = 3000 mm.

mm

From the floor to the ceiling or to the top of the wardrobe.

mm

From the front to the back wall.To hang clothes with sliding: minimum depth 596 mm.

With a width of 3,000 mm we recommend 3 sections with an interior opening of about 975 mm.The number of sections and doors follows the measurements until you choose otherwise.
97597597430002400
Scale diagram. Measurements in mm. Textures are for guidance; the grain may vary.

3 sections · 3,000 mm

Special features (optional)

Example values: change them to your own measurements.

Would you rather we went through it with you? Tell us about your project.

01

What this tool does, and what it doesn't

The configurator guides you as you design your wardrobe: it's an assistant that helps you organise your decisions rather than throwing out a random number. At the end you get a clear summary of what you've chosen, ready to send.

No price appears on screen. That's deliberate, because the cost depends on real measurements, the type of doors and what goes inside the wardrobe, so an automatic figure would be unreliable. A member of the team works it out after reading your configuration.

If yours is more of a special commission, a whole walk-in wardrobe or an unusual shape, you can still use it: fill in what you know and leave the rest to discuss by message.

Beige fitted wardrobes with wooden handles and open shelving beside a designer table in Baena
02

The steps, one by one

First you choose the type of wardrobe and tell us about the space: approximate width, height and depth. A few measurements taken with a pocket tape measure are enough to get started.

Then you choose the doors: sliding, hinged or bifold, in the finish you like best. Each option shows up in the summary so you can compare without losing sight of the whole picture.

The third step is the interior: how many hanging rails, shelves and drawers you need, and whether you'd like a shoe area or a top cupboard. Finally, you check the summary, add a comment if needed and send it. You can go back at any time and change a decision without starting from scratch.

Have you already measured the space?

Send us a photo and the approximate measurements on WhatsApp and we'll give you some initial guidance.

03

Measurements worth having to hand

  • 01

    You don't need a professional measuring visit to configure, but a few details will save a lot of back and forth. Measure the width at the bottom, middle and top, because the walls in a home are rarely perfect. Note the height up to the ceiling at two points, and the free depth.

  • 02

    Also look out for anything in the way: a skirting board, a radiator, a switch, a beam or the swing of the bedroom door. A photo of the space helps a lot when you write to us on WhatsApp.

  • 03

    If you're not sure about a measurement, leave it as approximate and say so in the comment. The team will take it into account and, if the project goes ahead, it will be checked on site.

04

What happens when you send your configuration

When you finish, the configurator prepares a WhatsApp message with your design and measurements. You check it and send it from your own phone to 624 754 588; there are no long forms and no sign-up beforehand.

The team receives it, looks at what you've described and replies with a guide price, at no cost to you. That figure is a reference to help you decide whether it's worth going further, not a final quote.

If you like what you see, the next step is the measuring visit at your home. It costs €50 if you end up not commissioning the work, and it's not charged if you do. Manufacturing usually takes 2 to 3 weeks on average, and the installation is arranged separately.

05

If you'd prefer another route

Not everyone wants to go through a tool. If you'd rather just write to us directly, you can do so from the contact page, or fill in the quote request form, which also prepares a message by WhatsApp or email.

And if you're still at the ideas stage, it's worth first looking at how we work to see in what order everything happens. The configurator will be there whenever you want to pick it up again.

Empty alcove in a bedroom with a tape measure, ready for a made-to-measure fitted wardrobe in Baena

Questions

Frequently asked questions about wardrobes in Baena

Will I see a price when I finish the steps?

No. The tool prepares your design and sends it; the guide price comes from the team once they receive the configuration with your measurements.

Do I have to give my phone number to use it?

You can go through the steps and view the summary freely. To send it, WhatsApp opens from your own phone, so you are the one who starts the contact when you decide to send it.

What if I'm not sure about the measurements?

Enter approximate ones and mention it in the comment. To get started, a reasonable idea of the width, height and depth is enough.

Can I change the configuration after sending it?

Yes. Write in the same chat with whatever you'd like to change and the team will adjust it before refining the price.

Can I use it if I'm after a walk-in wardrobe?

Yes, you can. If the space is tricky, mention it in the comment and it will be looked at in more detail.

Your idea is the first step.

Would you like us to go over your wardrobe with you? Tell us what you need and we'll agree the details during the visit.

If you've already put your design together, use "Send project via WhatsApp" in the configurator to share your selections.

Your satisfaction is our priority We listen to your ideas and go through the measurements, finishes and every detail of the project with you.
WhatsAppQuote